GE MG14200 - Manual (Page 10)

8 Chapter 1
Connections & Setup
VIDEO IN AUDIO IN ANT
TV (back panel)
IN FROM ANT
OUT TO TV
CH3
CH4 VIDEO AUDIO
VCR
SATELLITE RECEIVER
CH3
CH4
AUDIO VIDEO
IN FROM ANT
OUT TO TV SATELLITE
IN
Antenna
Satellite Signal
TV
VCR
Satellite
Connection: TV + VCR + Satellite Receiver
1. Connect your Satellite Receiver to your TV
A. Connect the white audio cable to the AUDIO IN jack on the back of the TV and to the Audio
Output Jack on the satellite receiver. If you have a stereo satellite receiver, use the L/MONO jack on
the back of the satellite receiver to make this connection. Let the red audio cable hang.
B. Connect the video cable (yellow) to the VIDEO IN jack on the back of the TV and to the Video
Output Jack on the satellite receiver.
2. Connect coaxial cables to the Satellite Receiver
A. Connect the coaxial cable from your cable outlet, cable box, or antenna to the Input Jack on your
satellite receiver (sometimes labeled IN FROM ANT).
B. Connect the coaxial cable from your satellite dish antenna to the Input Jack on your satellite
receiver (sometimes labeled SATELLITE IN).
3. Connect the Satellite Receiver to the VCR and to the TV
A. Connect a coaxial cable to the Output Jack (sometimes labeled OUT TO TV) on the satellite
receiver and to the Input Jack on the VCR (sometimes labeled IN FROM ANT).
B. Connect a coaxial cable to the Output Jack on the VCR (sometimes labeled OUT TO TV) and to
the ANT. jack on the TV.
Go to page 10
1A
1B
3A
3B
2A
2B