Grizzly G0527 - Manual (Page 18)

-16- G0527 18" Wide Belt Sander
To hook up the air line:
1. Connect the hose from your air compressor
to the air inlet (
Figure 7) on the regulator.
2. Make sure the red handle on the regulator is
in the open position (parallel with the air
inlet).
3. Lift the black regulator knob ( Figure 7) and
adjust it until the air pressure gauge reads 75
PSI. Note—
Turn the dial clockwise to
increase the air pressure and counterclock-
wise to lower the air pressure.
4. Push the regulator knob down until it snaps.
Figure 7. Air inlet located on regulator.
Dust Collection Air Line Hook-Up
Figure 8. Dust collection hook-up.
An efficient and clean dust collection system is
essential to the proper function of the sander.
Ensuring a healthy work environment is also
dependent upon cleaning and maintaining your
dust collection system.
To hook up the dust collection system:
1. Install the 4" dust port ( Figure 8) on the
mounting locations at the top of the sanding
unit with the supplied M6-1.0 x 10 phillips
head screws.
2. Clamp a hose from your dust collection sys-
tem to the dust port.
Air Inlet
Red Handle
(Closed Position)
Black
Regulator
Knob