Gateway 210 - Manual (Page 43)

39
Maintaining the projector
www.gateway.com
Cleaning the projector
Keeping the projector clean and the vents free from dust helps keep it
performing at its best.
Cleaning the exterior
Always turn off the projector and wait for it to cool before cleaning it.
Use a damp, lint-free cloth to clean the projector case. Do not use abrasive or
solvent cleaners because they can damage the finish.
The projector is cooled by air circulated through the vents on the case, so keep
the vents free of dust. With the projector turned off and unplugged, brush the
dust away from the vents with a damp cloth. Be careful not to drip any water
into the vents. Do not attempt to clean dust from the inside the projector.
Cleaning the projector lens
Always turn off the projector and wait for it to cool before cleaning it.
Use a soft cloth and glass cleaner to clean the projector lens. Squirt a little
cleaner on the cloth (never directly on the lens), and wipe the lens with the
cloth.
Keep the lens cap on when the projector is not being used to protect the lens.
Warning Make sure that the projector is off, power is disconnected,
and the lamp is completely cool (minimum of 30 minutes)
before cleaning the projector.