5 rebooting the handytone-496 from remote, 3 configuration through a central server, Rebooting the handytone-496 from remote – Grandstream Networks HandyTone-496 User Manual
Page 31: Onfiguration through a, Entral, Erver, Handytone-496 user manual, Grandstream networks, inc
HandyTone-496 User Manual
Grandstream Networks, Inc
.
31
Grandstream Device Configuration
Your configuration changes have been saved.
They will take effect on next reboot.
All Rights Reserved Grandstream Networks, Inc. 2005
Users are recommended to power cycle the HandyTone-496 after seeing the above message.
6.2.5 Rebooting the HandyTone-496 from Remote
The administrator of the HandyTone-496 can remotely reboot the HandyTone ATA by clicking on the
“Reboot” button at the bottom of the configuration page. Once done, the following screen will be
displayed to indicate that rebooting is underway.
Grandstream Device Configuration
The device is rebooting now...
You may relogin by clicking on the link below in 30 seconds.
All Rights Reserved Grandstream Networks, Inc. 2004
At this point, the user can relogin to the HandyTone-496 after waiting for about 30 seconds.
6.3 Configuration through a Central Server
Grandstream HandyTone ATAs can be automatically configured from a central provisioning system.
When HandyTone ATA boot up, it will send TFTP or HTTP request to download configuration file,
“cfg000b82xxxxxx”, where “000b82xxxxxx” is the MAC address of the HandyTone ATA.