Gemini GEM-RP8 - Manual (Page 15)

Ambush Code - In the event that you
are forced by an intruder to disarm your
system, this special code can be used
t o d i s a r m t h e s y s t e m , a n d
simultaneously send a silent alarm to
Central Station. If your system has the
Ambush feature enabled, the code
assigned as the User 8 code will
function as your Ambush Code.
Arming / Disarming - Turning the
system on or off by entering your user
code at the keypad, followed by
D.
Auto Interior Bypass - A feature which
allows the system to recognize when
you have not left the premises and
automatically bypass any interior zones,
deactivating devices such as motion
sensors, allowing free movement
throughout the premises.
Battery - A backup source of power to
provide protection for a limited time in
the event of a power failure.
Bypass - the manual or automatic
removal of one or more protection zones
from the system. Press
B and then
the zone number to bypass a zone.
Central Station - Monitors alarm,
emergency and trouble reports from the
alarm system and notifies proper
authorities.
Chime - a keypad beep which indicates
that a door has been opened while the
system is disarmed.
Easy Exit - Allows an occupant to leave
the premises without disarming the
system. Pressing
A and then
0 while the system is armed will
permit exit by removing the protection
on the Exit/Entry door for 3 minutes.
Exit/Entry Delay - The amount of time
you are allowed to enter and leave the
premises when the system is armed.
Exit/Entry Zone - A zone which will
allow you to enter and leave the
premises when the system is armed.
Instant Protection - Arming without
Entry Delay while remaining on the
premises. (Press
F while armed).
Keypad Sounder - A local warning
device at the keypad to alert that Entry
delay has started.
System Trouble - A problem has been
detected in the system which may
prevent it from working properly.
TROUBLE H will be lit to indicate a
system trouble.
User Code - A four digit code which is
used to arm and disarm the system from
the keypad.
User 1 Code - A four digit code which
can be used to program, re-program
and erase user codes, as well as arm
and disarm the system from the keypad.
Zone - An area which is protected by a
security device. Your front door may be
designated as Zone 1, while the living
room motion detector may be Zone 2.
Refer to the Zone Label on your keypad
for the Zone Identification of your
system.
15
G L O S S AR Y