Global Machinery Company CDB305MS - Manual (Page 12)

12
them to support the workpiece
(Fig. L).
The side support bar locking
screws (34) must be tightened
to secure the support bars in
position (Fig. M).
Turning on and off
1. To turn the saw on depress
and hold the on/off trigger
switch (24) (Fig. N).
2. To turn the saw off release
the on/off trigger switch (24).
Turning on the
REDEYE ® laser line
generator
The REDEYE ® laser line
generator emits 2 intense
narrow beams of pure red
light to guide you as you cut.
It improves operator cutting
vision, enables faster set-
up, increases accuracy and
improves safety. To turn on
the laser lines press the laser
light on/off switch (2) (Fig. O).
To turn off the laser press the
laser light on/off switch (2)
one more time.
Setting the table
square with the blade
1. Make sure that the
electrical plug is removed
from the power point.
2. Push the saw arm (5)
down to its lowest position
and engage the release
knob (6) to hold the saw arm in the transport position.
3. Loosen the mitre lock (25) (Fig. P).
4. Rotate the table (21) until the pointer is positioned at 0º.
5. Tighten the mitre lock (25).
6. Loosen the bevel lock (16)
and set the saw arm (5) at
0º bevel (the blade at 90º
to the mitre table). Tighten
the bevel lock (16) (Fig. Q).
7. Place a set square against
the table (21) and the flat
part of the blade. (Fig. R)
Note. Make sure that
the square contacts the flat
part of the saw blade, not
the teeth.
8. Rotate the blade by
hand and check the
blade-to-table alignment at
several points.
9. The edge of the set square
and the saw blade should be parallel.
10. If the saw blade angles away from the set square,
adjust as follows.
11. Use a 13mm wrench or adjustable wrench to loosen
the lock nut securing the 0° bevel adjustment screw
(35) (Fig. S). Also, loosen the bevel lock (16).
M
N
O
P
Q
R
90°
S T