GoVideo DP 5050 - Manual (Page 9)

9
Charging the Battery Pack While it is
Attached to the Player
1 Connect the battery pack to the back of the
player as shown.
2 Plug the supplied AC adapter into a standard
power outlet, and then connect it to the DC In
jack on the right side of the player.
3 Turn off the player. The battery pack will
NOT charge while the portable DVD player is
powered on.
4 The battery charge indicator will turn red while
the battery is charging.
5 The battery charge indicator will turn green
when the battery pack is fully charged.
Removing the Battery Pack
• Press the Battery Release button on top of the
battery pack to remove it.
CAUTION
• Use the specified battery pack only.
• May explode if battery pack is
incorrectly replaced or disposed of
in fire. Replace only with the same
or equivalent type.
• Do not short circuit.
• Do not place the battery pack in direct sunlight
or in excessively hot places (over 140°F (60°C)
such as the dashboard of cars.
• Use only with the specified power adapter
(12VDC, 1.25A).
Quick Start
Battery Pack Overview
1 DC In Jack
2 Battery Release Button
3 Battery Charge Indicator
4 Battery Connectors
Charging the Battery Pack
Before using the battery pack, make sure it is fully
charged. You can charge the battery pack directly
or while it is attached to the portable DVD player.
Charging the Battery Pack Directly
1 Plug the supplied AC adapter into a standard
power outlet, and then connect it to the DC IN
jack on the left side of the battery pack.
• You can also use the supplied cigarette
lighter adapter in place of the AC adapter to
charge the battery.
2 The battery charge indicator will turn red while
the battery is charging.
3 The battery charge indicator will turn green
when the battery pack is fully charged.
• Allow ~3 hours to fully charge the battery.
• A fully charged battery permits ~3 hours of
playback time.
DC In Jack
4
2 1 3