Grizzly G0547 - Manual (Page 16)

-14- G0547 Combo Sander
The Model G0547 Combo Sander accepts 6"
diameter cloth or paper-backed pressure sensi-
tive adhesive (PSA) sanding discs. These are
available in a variety of grits. See the current
Grizzly catalog for prices and ordering informa-
tion.
The PSA sanding disc sticks directly to the sur-
face of the aluminum disc and can be replaced
without removing either the table or the dust port.
To attach sandpaper:
1. Disconnect the machine from the power
source!
2. Remove the disc table and the lower guard.
3. Remove the worn out sandpaper.
Note— Make sure that all dust, grit, and
adhesive from the old sandpaper is cleaned
off the aluminum disc. This will ensure a
good bond between the sandpaper and the
disc.
4. Peel back the protective layer on one-half of
the sandpaper disc and fold it against the
remaining half.
Figure 8. Center the sandpaper on the disc.
5. Center the sticky half of the sandpaper on
the upper half of the disc and press the sand-
paper onto the surface (
Figure 8).
6. Remove the remaining half of the protective
layer and then press this portion against the
disc.
7. Rotate the disc by hand and check to make
sure the sandpaper is firmly attached to the
disc. Note—
DO NOT turn the disc sander on
at this point.
Attaching Sandpaper
!