Geneva Lab FRESH BREW 3206 - Manual (Page 21)

G E N E V A
-
H O T B E V E R A G E M E R C H A N D I S E R • 3 2 0 5 • 3 2 0 6 • 4 2 1 4 8 0 3
19
• Figure 13e - Remove the filter carriage by
sliding it towards you.
Figure 13e
• Figure 13f - Unclip/Detach the Sealing Rod
Connector by pulling towards you.
Important:
When re-assembling do not forget to
reconnect the Sealing Rod
Figure 13f
• Figure 13g - Holding the Brewing Chamber
as shown pull it gently towards you to
remove it
Figure 13g
• Figure 13h - Lift off he Steam Extractor
Hood
Important:
When replacing the Steam Extractor Hood
ensure it is located behind the release catch
and that it is sat-down properly as shown.
Figure 13h
• Use de-staining product to clean the Brewer, cylinder, steam trap and carriage assembly. Then
rinse all parts thoroughly with clean water.