Grizzly G0719 - Manual (Page 18)

-16-
model g0719 (mfg. since 10/10)
figure 10. sander installation.
figure 11. Fully assembled sander.
6. With the help of another person, place the
sanding unit onto the top of the cabinet, as
shown in
figure 10, and fasten it to the cabi-
net using (4) m8-1.25 x 45 hex bolts and (4)
5 ⁄
16
" flat washers.
7. Adjust the feet as necessary to level the
machine, then tighten the hex nuts against
the cabinet base.
8. make sure that all tools and objects used for
setup are cleared away from the machine.
the machine is now fully assembled and
ready for the test run procedure.
power Connection
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the
POWER
SUPPLY section in this manual, and all previ-
ous setup instructions in this manual must be
complete to ensure that the machine has been
assembled and installed properly.
Connecting power
figure 12. Connecting power.
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Disconnecting power
figure 13. Disconnecting power.
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.