GE 165D4700P371 User Manual

Page 13

Consumer

uppor

Operating

Instructions

Safety

Instructions

Car

Instructions

oubleshooting

Tips

Problem

Possible Causes

What To Do

Dishwasher won’t run

Fuse is blown, or the

• Replace fuse or reset circuit breaker. Remove any other appliances

circuit breaker tripped

from the circuit.

Power is turned off

• In some installations, the power to the dishwasher is proved through a

wall switch, often located next to the disposer switch. Make sure it is on.

Reboot your control

• Turn off power to the dishwasher (at circuit breaker or wall switch) for

30 seconds, then turn back on.

Steam

This is normal

• Steam comes through the vent during washing, drying and when

water is being pumped out.

Control panel

Door latch may not be

• Make sure the door is firmly closed.

responded to input

properly seated

but dishwasher never
filled with water

Water valve may be

• Make sure water valve (usually located under the sink) is turned on.

turned off

Dishwasher beeps

This is normal

• Close the door after opening it mid-cycle.

once every 15 seconds

This is a reminder that the

• Press ON/OFF to turn OFF the dishwasher.

door has been left open
during operation

Beeping at the end

This is normal

• The dishwasher will beep and the CLEAN light will display at the end

of the cycle

of the wash cycle.

LOW RINSE AID

Rinse aid dispenser

• This can only be turned off by filling the rinse aid dispenser with Jet-Dry

light is on

needs to be refilled

or Cascade Crystal Clear

See Refilling the Rinse Aid Dispenser section.

ge.com