Grizzly H8219 - Manual (Page 7)

Model H8219 Air Orbital Sander -5 -
Using the Sander
1. Plug the tool into compressed air regu-
lated at 90 PSI.
2. Hold the sander firmly and press the
throttle lever ( Figure 3) to turn it ON.
3. Turn the regulator knob (Figure 3) to
adjust the speed of the air sander.
Daily Maintenance
The air sander MUST have 2-6 drops of oil
dropped directly into the air fitting before
and after each use.
A filter/lubricator/regulator set up is not
recommended, as excess oil in the tool
could spray onto the workpiece.
Run the sander for a few minutes to eject
excess oil, then wipe the tool down with a
rag and begin sanding. Oil the tool after
use or storage.
ACCIDENTAL
START HAZARD!
Disconnect before
service or tool
changes.
AIR PRESSURE
HAZARD!
Never exceed max
PSI rating for tool.
LUNG/EAR
INJURY HAZARD!
Wear protective
equipment when
using this tool.
EYE INJURY
HAZARD!
Wear protective
equipment when
using this tool.
4. Remove pressure on the throttle lever
to stop the sander.
5. When the sandpaper loses its effective-
ness, remove sandpaper from the pad,
and replace with a new piece.
Throttle Lever
Regulator Knob
Figure 3. Sander controls.
These procedures should be done after
each use:
• Wipe the housing with a dry cloth, or
blow off the dust and debris with com-
pressed air.
• Check for damage to tooling, hoses,
housing or other accessories.
To avoid accidental starting, disconnect
the sander from the air supply when it
is not in use.