Grizzly H8219 - Manual (Page 6)

Model H8219 Air Orbital Sander -4 -
OPERATIONS
Read the manual before operation.
Become familiar with this tool, its
safety instructions, and its operation
before beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.
Like all tools there is potential danger
when operating this tool. Accidents
are frequently caused by lack of
familiarity or failure to pay attention.
If normal safety precautions are
overlooked or ignored, serious
personal injury may occur.
Attaching Sandpaper
1. DISCONNECT THE SANDER FROM
THE AIR SUPPLY!
2. Install the 1 ⁄
4
" NPT male quick-connect
fitting into the air inlet.
3. The sanding pad for the Model H8219
measures 6 1 /
2
" X 3 1 /
2
". New sandpaper
sheets can be obtained by cutting down
a single sheet or a piece from a roll.
Cut at least 2 1 /
2
" extra for the length to
fasten it properly.
Note: Using sandpaper that is torn or
is smaller than the sanding pad will
cause excessive wear and damage
your sander.
4. Attach the sandpaper by clamping it
onto both ends of the sander with the
paper clamps as, shown in
Figure 2.
5. Firmly press the paper clamps until the
holding spikes ( Figure 2) push through
the sandpaper.
Figure 2. Attaching the sandpaper.
Paper Clamp
Holding Spikes