Graco Assura ISPC116BA - Manual (Page 28)

26
Pull on latch plate (fig. b). If belt slides freely
through latch plate, a locking clip MUST
be used (see Locking Clip section).
Some combination lap/shoulder belts with
sliding latch plates may be converted into an
“automatic locking mode” that will allow use
without a locking clip. See vehicle owner’ s
manual and label on vehicle belts for
instructions.
❃
Combination Lap/Shoulder
Belt with Sliding Latch Plate
❃
Combination Lap/Shoulder
Belt with Locking Latch Plate
The locking latch plate on some seat belts may
slip and loosen after being buckled on car seat if
positioned at a certain angle. If this happens,
flip the latch plate over (fig. c) and re-buckle.
Test installation again to see if this works. If
not, move car seat to another seating position.
VEHICLE SEAT BELTS
(continued)
(fig. b)
Pull
(fig. c)
Flip