Graco Assura ISPC116BA - Manual (Page 14)

12
INSTALLATION WITH VEHICLE SEAT BELT
Place car seat rear-facing on vehicle seat.
Thread vehicle lap belt through car seat Slots
and buckle belt.
NOTE: Vehicle shoulder belt must NOT be
placed through car seat Slots.
Press down firmly on car seat to compress
vehicle seat cushion while tightening vehicle
lap belt (fig. a).
1
2
3
4
5
6
Pull front to back and left to right to check for
secure installation (fig. b). Vehicle lap belt
MUST stay tight.
If not secure, see “Vehicle Seat Belts”
section, p.22.
Check level indicator on car seat.
Vehicle must be on level ground
and child in car seat when checking level
indicator.
Ball MUST be entirely in green zone (fig. c). If
necessary, place rolled towels under car seat, at
vehicle seat crease, until entire ball is in green
zone. Then re-check level indicator.
Adjust handle to a position behind car seat.
Periodically check that car seat is securely
installed and properly leveled; adjust if
necessary.
LATCH belt MUST be stored when
using vehicle seat belt to install car
seat. See “LATCH Storage” on p. 29.
WARNING