Grandstream Networks HANDYTONE 486 - Manual (Page 13)

HandyTone-486 User Manual Grandstream Networks, Inc.
13
6 Configuration Guide
6.1 Configuring HandyTone-486 WAN IP through Voice Prompt
6.1.1 DHCP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-486 to use DHCP.
6.1.2 STATIC IP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-486 to use STATIC IP mode, then
use option 02, 03, 04 to set up HandyTone’s IP, Subnet Mask, Gateway respectively.
6.2 Configuring HandyTone-486 with Web Browser
HandyTone-486 series ATA has an embedded Web server that will respond to HTTP GET/POST
requests. It also has embedded HTML pages that allow a user to configure the HandyTone through a
Web browser such as Microsoft’s IE and AOL’s Netscape.
6.2.1 Access the Web Configuration Menu
The HandyTone-486 HTML configuration menu can be accessed via LAN or WAN port:
• From the LAN port use the default LAN gateway IP address (this can be changed to any private
LAN segment by user, just make sure WAN and LAN are using different LAN segment if
HT486 WAN side is connected behind a SOHO router in SOHO router’s LAN port):
http://192.168.2.1
• The WAN port HTML configuration menu option is disabled from factory. To access the
HTML configuration menu from the WAN port, first enable the “WAN side HTTP access”
option by accessing the configuration via HT486’s LAN port.
With the WAN side HTTP access enable, then get the WAN IP address of the HandyTone
through IVR (section 5.1 with menu option 02). Then the HandyTone’s Web Configuration
Menu can be accessed by the following URI via WAN port:
http://HandyTone-IP-Address,
where the HandyTone-IP-Address is the WAN IP address of the HandyTone-486.