GE Monogram 36 - Manual (Page 7)

Before Using Your and Dispenser
If you use your refrigerator
before the water connection is
made, raise the ice access door
and make sure the
feeler arm is in the STOP (up)
position as shown below.
When water supply has b
connected to
move feeler arm to ON
(down) position.
Move selector switch to
CHILLED WATER and
depress dispenser cradle
arm in
for about 2 minutes to
(up)
remove trapped air from t
water line and to fill water reservoir automatically.
Ice cube mold automatic
fills with water after
cooling to freezing
temperatures. First
cubes normally freeze
after several hours.
NOTE: With a in
installed refrigerator,
allow about 24 hours for
the freezer compartment to cool down to the proper
ice-making temperature.
Once Your and Dispenser are in Operation
Throw away the first few batches of ice cubes
Keep ice level to keep productive. Cubes
(16 or 24 cubes). This will flush away any impurities ejected into an empty storage bin will pile up close to
in the water line. Do the same thing after vacations or the and push the feeler arm up to the STOP
extended periods when ice isn’t used.
position prematurely when the bin is only partially full.
Discard the first 6 of water in the kitchen sink. Open the ice access door, reach in, level the cubes by
This will eliminate the slight “plastic” taste temporarily hand and will resume. Keeping cubes
imparted to the water by the water reservoir. distributed evenly will allow the to produce
enough ice to fill the bin to its maximum capacity.
To Dispense Ice and Water
For ice, set selector
switch to CUBED,
CRUSHED or
CHILLED WATER. Grip glass or
other container
gently near the
rim and press rim
firmly against
dispenser cradle.
CAUTION: Never put fingers or other objects into the ice crusher discharge opening.
I
(continued next page)
7