GE Monogram 36 - Manual (Page 17)

Read
How to connect electricity
For personal safety, this appliance must be properly grounded.
The power cord of
this appliance is
equipped with
a 3-prong
(grounding) plug
which mates with a
standard 3-prong
(grounding) wall
outlet to minimize
the possibility of
DO NOT USE AN ADAPTER PLUG TO
CONNECT THE REFRIGERATOR TO A
2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH
electric shock hazard
INSURE PROPER GROUND THIS APPLIANCE.
from this appliance.
EXISTS BEFORE USE
The refrigerator should always be plugged into
Have wall outlet and circuit checked by a qualified
electrician to make sure outlet is properly grounded,
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to
have it replaced with a properly grounded 3-prong
wall outlet.
Refrigerator Location
Install the refrigerator on a floor strong enough to
support it when it is fully
Do not install refrigerator where temperature will
go below
because it will not run often enough
to maintain proper temperatures.
its own individual electrical outlet which has a
voltage rating that matches the rating plate.
This provides the best performance and also prevents
overloading house wiring circuits which could cause a
fire hazard from overheated wires.
The water line and the electrical outlet
must be installed in the exact location described in the
Installation Instructions (Pub. No. 49-6473—36),
(Pub. No. 49-6462—42), (Pub. No. 49-6457—48).
Clearances
If the refrigerator is to be installed in a corner, allow
2“ between the hinges of the refrigerator and the wall
to assure a 90° door opening capability.
No other clearances at top, sides or back are required.
Leveling
This model has 4-point leveling. 4 corners are
supported by leveling legs. The front wheels are non-
adjustable; they are only used for positioning the unit.
●
To level the back of the unit, turn hex nut located
above the front wheels.
●
To level the front of the unit, use a 11/4” open end
wrench and adjust the leveling legs.
●
Turn hex nut or front leveling leg clockwise to raise
the unit, counter-clockwise to lower the unit.
Leveling leg
See the Installation Instructions
(Pub. No. 49-6473—36), (Pub. No. 49-6462—42),
(Pub. No. 49-6457—48) for complete directions.
17