beautypg.com

Power saver switch, Temperature controls, Your – GE Monogram 36 User Manual

Page 5: Set temperature controls, How to test temperatures, No defrosting

background image

YOUR

Set Temperature Controls

Your refrigerator has two controls

that let you regulate the temperature
in the fresh food and freezer

5 IS NORMAL

compartments.

FRESH

They have settings from 1 through
9, and are located at the top of the
fresh food compartment.

NORMAL

The freezer control also has

FREEZER

an OFF setting.

9 is the coldest setting, 1 is the warmest.

WHEN YOU FIRST TURN THE
ON, SET BOTH CONTROLS AT 5.

For colder or warmer temperatures, adjust the desired
compartment control 1 number at a time.

IMPOR

TANT

:

When first setting controls, or

adjusting them, allow 24 hours for the refrigerator
to get cold.

NOTE:

the freezer control to the OFF

position stops cooling in BOTH
fresh food AND freezer—but does not shut off
power to the refrigerator.

How to Test Temperatures

Use the milk test for the fresh

Use the ice cream test for the

food compartment. Place a

freezer compartment. Place a

container of milk on the top shelf
in the fresh food compartment.

center of the freezer compartment.

Check it a day later. If the milk is

Check it after a day. If it’s too

too warm or too cold, adjust the

hard or too soft, adjust the

temperature controls.

temperature controls.

Power Saver Switch

The power saver switch is located
on the temperature control panel.

To reduce the amount of electricity required
to operate your refrigerator, push switch to

POWER SAVER setting.

This turns off the heater in your refrigerator that

prevents moisture from forming on the outside of the
refrigerator.

With the heater turned off, there is a chance that
moisture may form on the outside of your refrigerator,

especially when the weather is humid.

The humidity is most likely to be high in the summer,
in the early morning hours, and in homes which are

not air conditioned.

Over an extended period of time, moisture that forms

on the refrigerator surface may cause deterioration of
the paint finish. It will be important to protect the
finish by using appliance polish wax as described in
the Care and Cleaning section.

Move the power saver switch from the POWER
SAVER setting and
electricity flows through the low
wattage heater which warms the outside of the

refrigerator. Under most conditions, this prevents the
forming of moisture or water droplets.

No Defrosting

It is not necessary to defrost the freezer or fresh food
compartments. Although your refrigerator is designed
and equipped to defrost itself automatically, some

frost on packages is normal.

5