Grizzly H8218 - Manual (Page 5)

Model H8218 Mini Die Grinder -3 -
INTRODUCTION
A. 1 /
4
" Mini Die Grinder
B. 1 /
4
" NPT Male Quick Connect Fitting
C. 12mm Wrench
D. 17mm Wrench
Collet Size............................................... 1 ⁄
4
"
No Load Speed.......................25,000 RPM
Air Consumption...............................3 CFM
Air Inlet..................................................... 1 ⁄
4
"
Required PSI.....................................90 PSI
Maximum Sound Level......................95 dB
No list of safety guidelines is complete,
because every work environment is
different. Always consider safety first
and use common sense. Failure to
use this tool with caution and respect
could result in serious personal
injury.
Specifications
Figure 1. Model H8218 Inventory.
A
B
C
D
Foreword
The specifications, details, and
photographs in this manual represent
the Model H8218 as supplied when the
manual was prepared. However, owing to
Grizzly’s policy of continuous improvement,
changes may be made at any time with no
obligation on the part of Grizzly.
If you have any comments regarding this
manual, please write to us at the following
address:
Grizzly Industrial, Inc.
C/O Technical Documentation
P.O. Box 2069
Bellingham, WA 98227-2069
E-Mail: [email protected]
Most importantly, we stand behind our
tools. If you have any service questions or
parts requests, please call or write us at
the location listed below.
Grizzly Industrial, Inc.
1203 Lycoming Mall Circle
Muncy, PA 17756
Phone: (570) 546-9663
Fax: (800) 438-5901
E-Mail: [email protected]
Web Site: http://www.grizzly.com