beautypg.com

Garmin GPSMAP 4000 User Manual

Page 67

background image

GPSMAP 4000 Series Owner’s Manual

a

ppendIX

a

ppendi

X

Simulating Operation—the unit is in simulator mode.
Sonar Failed, Unit Needs Repair—there has been a sonar failure and the unit needs to be sent in

for repair. Contact product support.
Sonar Service Incompatible. Software Update Required—a software update is needed. Contact

product support for assistance updating your network.
Sonar Service Lost—(sonar) the unit has lost communications with the remote sonar unit. Check

the network and the sonar wiring.
Tide Alarm—tide has reached user-specified tide alarm range.
Tornado Warning Alarm—(XM WX weather) a tornado warning is in effect.
Track Already Exists—the named track already exists. Choose another name.
Track Log Full—there is no longer any space in the active track log storage.
Track Memory is Full, Can’t Create Track—the saved track memory is full.
Track Truncated—some points on the end of the track have been discarded.
Transducer Disconnected, Sonar Turned Off—the transducer has been disconnected. Sonar has

been turned off. Check transducer wiring.
Transfer Complete—user data transfer is complete.
Unknown bridge height within calculated auto-guidance route—(BlueChart g2 Vision) there is

an unknown bridge height within auto-guidance route.
User Card Not Found—user data card transfer. Make sure an SD card is fully inserted.
Warning: Auto-guidance route starting position moved due to safe depth settings

(BlueChart g2 Vision) auto-guidance has calculated the route, but the starting point has been moved

to deeper water.
Warning: Auto-guidance route ending position moved due to safe depth settings

(BlueChart g2 Vision) auto-guidance has calculated the route, but the end point has been moved to

deeper water.
Water Speed Sensor is not Working—the water speed sensor is not working properly. Check the

wheel for obstructions and check wiring.
Water Temperature Alarm—(temperature sensor/transducer) the water temperature has entered or

left the user-defined water temperature alarm zone.
Waypoint Already Exists—the named waypoint already exists. Choose another name.
Waypoint Memory is Full, Can’t Create Waypoint—the User Waypoint memory is full. Erase

existing waypoints to make room.
Weather Service Incompatible. Software Update Required—an XM WX weather software

update is needed. Contact product support for assistance updating your network.
Weather Service Lost—(XM WX weather) the weather service is no longer communicating. Make

sure you have a strong XM signal. Check the network and the XM wiring.
XM Service Incompatible. Software Update Required—an XM service software update is

needed. Contact product support for assistance updating your network.