Grizzly Air Palm Sander g5344 User Manual

Model g5344 air palm sander, Instruction sheet, Introduction

Introduction

This 15,000 RPM air sander requires 75 PSI and
3" x 4

" sanding sheets. (You can cut a standard

9" x 11" sanding sheet into sixths and trim each
piece to size.) Air hose inlet is

" NPT.

Inventory

A. Air Palm Sander ......................................... 1

B. Air Hose ...................................................... 1

MODEL G5344

AIR PALM SANDER

INSTRUCTION SHEET

Figure 2. Opening clamp.

Figure 1

Model G5344.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#BL8253 PRINTED IN TAIWAN

Assembly and Attaching Abrasives

To assemble the sander and attach sandpa-

per:

1. Thread the air hose into the sander.

2. Install a

⁄

" NPT male quick-disconnect fitting

(not included) into the end of the hose.

3. Lift one clamp up over the bracket (Figure 2),

then pull the clamp down to open it.

4. Insert one end of the sandpaper between the

clamp and base as shown in

Figure 3, and

lift the clamp up and back over the bracket to
secure the sandpaper.

Figure 3. Attaching and securing sanding sheet.

Bracket

EYE INJURY HAZARD!

Always wear safety glasses

when using this tool to

prevent serious personal

injury.

INJURY HAZARD!

Always disconnect tool from

air to prevent unexpected

operation during service.

DUST HAZARD!

Always wear respirator when

using this tool.