Gold's Gym GGBE1774.0 - Manual (Page 8)

8
6. Attach the Support Frame (15) to the Upright
Base (3) with an M10 x 62mm Bolt (24) and an
M10 Nylon Locknut (44).
Do not tighten the
Locknuts yet.
Attach the Support Frame (15) and the Left and
Right Legs (6, 7) to the Backrest Frame (8) with
four M10 x 53mm Bolts (30) and four M10 Nylon
Locknuts (44).
Tighten the M10 Nylon Locknuts (44) and M8 x
15mm Screws (49) used in steps 2–6.
7. Attach a Pull-up Handle (13) inside the Top
Frame (5) with four M8 x 19mm Screws (38) and
four M8 Curved Washers (39).
Slide a 51mm Round Outer Cap (23) onto the
Pull-up Handle (13) and press the Cap into the
Top Frame (5).
Repeat this step on the other side of the Top
Frame (5).
8
6
7
7
15
44
44
44
24
30
30
6 3
39
39
38
38
38
38
23
5
13
8. Attach the Pad Frame (10) to the Pivot Arm (9)
with two M8 x 19mm Screws (38), two M8
Washers (37), and two 5mm Spacers (34).
10
34
34
37
38
9
8
37
38