Grizzly Model G8027 - Manual (Page 19)

G8027 1 HP Dust Collector -17-
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
Turn on the power supply at the main panel.
Turn the dust collector
ON. Make sure that your
finger is poised on the toggle switch just in case
there is a problem. The dust collector should run
smoothly, with little or no vibration or rubbing
noises. Strange or unnatural noises should be
investigated and corrected before operating the
machine further.
If you cannot easily locate the source of an
unusual noise or vibration, contact our service
department for help.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Wear safety glasses dur-
ing the entire operations
process. Failure to com-
ply may result in serious
personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Operating your Model G8027 is simple and
straightforward. Move the dust collector to the
machine location, connect the duct, connect the
ducting ground, and you are ready to begin.
Always wear a respi-
rator when operating
your dust collector. This
machine circulates saw-
dust dust which may
cause allergic reactions
or respiratory problems. DO NOT use the dust collector for any
other purpose besides collecting dust from
connected woodworking machines. A dust
collector should NEVER be used as an air
cleaner. For safest use, wear a respirator
and use an air cleaner in addition to the
dust collector.
General
Test Run
SECTION 4: OPERATION
Operation Safety