Grizzly G1030Z2 - Manual (Page 18)

-16-
Model G0562Z/ZP, G1030Z2/Z2P (Mfg. 11/11+)
11. trim the excess foam strip so the ends come
together evenly, as shown in figure 18.
13. g0562z/g0562zp only:
a. install the canister handle onto the
top of the canister filter by tightening
the bolt against the flat of the shaft
(see
figure 20).
figure 18. trimmed foam strip.
10. affix the wide foam strip around the outside
top rim of the collector, as shown in figure
17.
figure 17. installing wide foam strip.
figure 20. installing canister handle.
b. place the canister filter on top of the
collectors.
c. position the metal belt clamp around
the bottom of the canister and latch it
so it evenly compresses against the
foam strip (see
figure 17).
figure 21. installed canister.
d. repeat a–c for the other canister.
Flat
12. secure the narrow foam strip around the out-
side bottom rim of the collector and trim the
excess, as shown in
figure 19.
figure 19. trimmed foam strip and collector
hook locations.
Collector hooks
narrow Foam strip