Epson 74c - Manual (Page 68)

68 Maintaining and Transporting the Projector
6. Use the screwdriver to loosen the two screws holding the lamp in
place. The screws are deep inside the projector on the sides of the
lamp. (You can’t remove the screws.)
7. Hold the lamp by the top, as shown, and pull it straight out.
8. Gently insert the new lamp as shown below.
9. Once the lamp is fully inserted, tighten its screws.
Don’t remove these screws
warning
This product includes a lamp
component that contains
mercury. Please consult your
state and local regulations
regarding disposal or
recycling. Do not put it in the
trash.
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.