Grundig XENTIA LXW 94-8625 - Manual (Page 8)

Connection to
External equipment
8
- You can connect additional equipment, such as VCRs, camcorders etc. to your set. However please check with your
manufacturers instruction books for specific information. Make sure all connections are made with both your set and
additional appliance unplugged from the mains to avoid damaging your equipment. Here shown may be somewhat dif-
ferent from your set.
Connect the RF out socket of the VCR to the aerial
socket on the back of the set.
Connect the aerial cable to the RF aerial in socket
of the VCR.
Store the VCR channel on a desired programme
number using the ‘Manual programme tuning’ sec-
tion.
Select the programme number where the VCR
channel is stored.
Press the PLAY button on the VCR.
Connect to Aerial socket
- If you connect an S-VIDEO VCR to the S-VIDEO input, the pic-
ture quality is improved; compared to connecting a regular VCR
to the Video input.
- To avoid picture noise (interference), leave an adequate dis-
tance between the VCR and set.
Use the INPUT SELECT button on the remote control to select
AV1 or AV2 .
(If connected to S-VIDEO, select the S-Video external input
source.)
Insert a video tape into the VCR and press the PLAY button on the
VCR. (See VCR owner’s manual)
Watching VCR
SER
VICE
OPTICAL
S-VIDEOS-VIDEO
ANTANT
. IN. IN
AC INPUTAC INPUT
VCR
SERVICE OPTICAL S-VIDEO S-VIDEO ANT ANT. IN . IN
AV1 V1
VIDEO VIDEO AUDIO AUDIO L R
AV2 V2
VIDEO VIDEO AUDIO AUDIO L R
S-VIDEO OUT
IN
(R) AUDIO (L) VIDEO
1 1 2 2
< Back panel of the set >
< Back panel of the set >
< Back panel of VCR >