Grizzly Model G0638 - Manual (Page 26)

-24-
G0637/G0638 Cyclone Dust Collector
Dust Collection Drum Assemblies
1. For each lower collection drum cylinders,
attach the casters to the bottom using (4) 3 ⁄
8
"-
16 hex nuts, (4) 3 ⁄
8
" flat washers, and (4) 3 ⁄
8
"
lock washers (see Figure 32).
Figure 32. Dust collection drum casters installed.
Small Cyclone Funnel and Funnel
Port
1. Apply the 3 x 6 x 2200mm gasket to the larg-
er, top end of the small cyclone funnel, then
place the cyclone funnel upside down on the
floor.
Note: Use a clean covering on the floor to
protect the gasket.
2. Apply the 3 x 6 x 735mm gasket to the top of
the funnel port and place this upside down on
top of the cyclone funnel.
3. Attach the small cyclone funnel and funnel
port with (6) 5 ⁄
16
"-18 x 1 1 ⁄
4
" hex bolts, (12) 5 ⁄
16
"
flat washers, and (6) 5 ⁄
16
"-18 hex nuts.
4. With assistance, attach this assembly to the
bottom of the large cyclone funnel with (9)
5 ⁄
16
"-18 x 1 1 ⁄
4
" hex bolts, (18) 5 ⁄
16
" flat washers,
and (9) 5 ⁄
16
"-18 hex nuts (see Figure 31).
Figure 31. Small cyclone funnel and funnel port
attached.
Funnel
Port
Small
Cyclone
Funnel
2. Connect each upper and lower collection
drum cylinder with a collection drum clamp
and use (1)
5 ⁄
16
"-18 x 3" hex bolt and (1) 5 ⁄
16
"-
18 hex nut to tighten the clamp (see Figure
33).
Figure 33. Installing drum clamp around dust
collection cylinders.