Grizzly Model G0638 - Manual (Page 25)

G0637/G0638 Cyclone Dust Collector
-23-
5. Attach the two long brace supports to the
filter braces with (4) 3 ⁄
8
"-16 x 3 ⁄
4
" hex bolts, (8)
3 ⁄
8
" flat washers, and (4) 3 ⁄
8
"-16 hex nuts, as
shown in Figure 27.
Figure 27. Long brace supports attached.
6. With assistance, position the rubber mount-
ing gaskets between the filter canisters and
the long brace supports, and secure the can-
isters with (8)
5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts and (8)
5 ⁄
16
" fender washers (see Figure 28).
Figure 28. Canister filters mounted to the long
support braces.
Rubber
Gaskets
Here
Mounting
Bolts
7. Assemble the 8" x 31 1 ⁄
2
" flexible ducts, the
noise mufflers, and the 8" x 4 3 ⁄
4
" flexible ducts
with the 8" duct clamps (see Figure 29).
Figure 29. Ducting and noise muffler connected
between blower housing and filter canister.
8. Use the 8" duct clamps to connect the duct
assemblies between the outlet port of the
blower housing and the canister filters.
9. Fit the plastic collection bags over the bottom
of the filters and clamp in place with the metal
bag clamps, as shown in
Figure 30.
Flexible
Ducts
Noise
Muffler
Figure 30. Canister filter collection bag installed.
Bag Clamp