beautypg.com

Remove generator from carton, Carton contents, Check battery / attach negative battery wire – Generac SE10000 User Manual

Page 4

background image

Generac Portable Products SE10000 Generator

4

Your generator requires some assembly and is ready

for use after it has been properly serviced with the

recommended oil and fuel.
If you have any problems with the assembly of

your generator, please call the generator helpline

at 1-800-270-1408.
IMPORTANT: Any attempt to run the engine before it

has been serviced with the recommended oil will

result in an engine failure.

REMOVE GENERATOR

FROM CARTON

• Set the palleted carton on a rigid flat surface.
• Carefully cut bands around the shipping carton.
• Lift carton off the generator.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping pallet.

CARTON CONTENTS

Check all contents. If any parts are missing or

damaged, call the generator helpline at

1-800-270-1408. Contents include:
• 10,000 watt generator
• Generator owner’s manual
• Engine owner’s manual
• 2 Bottles of SAE 30 engine oil (28 oz.)
• Oil fill spout
• 125 Volt, 30 Amp plug
• 125 Volt, 20 Amp plug
• 120/240 Volt, 30 Amp plug
• Wheel kit

CHECK BATTERY / ATTACH

NEGATIVE BATTERY WIRE

The battery on the generator is fully charged, sealed

and pre-installed except for the negative (black)

battery cable.
To install:
• Remove nut on the negative battery terminal.
• Slide the negative battery cable over the screw on

the terminal (Figure 2).

• Reattach nut and tighten.
• Ensure the connections to the battery and generator

are tight and secure.

Figure 2 — Negative Battery Connection