GE ZDWC240 - Manual (Page 13)

Reversing the Door Swing
Wine Chiller
13
Remove
Top Hinge
Remove
Hinge
Install
3 Hinge
Screws
Hinge
Pin
Cam
Riser
To reverse
the door To remove the door:
1. Remove 2 screws holding toekick.
2. Remove hinge plug cover on top left
side of cabinet.
3. Flatten the shipping carton to use as
a pad for the door.
4. Remove the 3 screws holding the top
case hinge.
5. Lift off case hinge, it will not be used
again.
6. Lift door off bottom case hinge.
7. Remove bottom case hinge and cam
riser.
8. Remove fill plug and screw on top right
side of door.
9. Remove door hinge, door stop and screw
from bottom right side of door.
Rotate the door:
Handle will be on right side of door, hinges
will go on the left.
To reinstall the door:
1. Install bottom case hinge from kit and
cam on the left side of the unit.
2. Install door hinge and door stop to
bottom left of door.
3. Install fill plug on top left of door.
4. Place door on bottom case hinge.
5. Install top case hinge from kit on top
left of cabinet.
6. Install hinge plug cover on top right
of unit.
7. Move plug on toekick to opposite side.
8. Install toekick. Verify that spacers are
attached to screw holes.
9. Install Monogram nameplate on door.
10. Put remaining case hinges in bag for
possible future use.
Note: Verify that door is on straight and
screws are tightened. If not, the door
will sag.
Position new nameplate:
Remove the old nameplate and stick the new
Monogram nameplate on the door using the
template included.