English – GIGABYTE GA-8I865GME-775-RH User Manual

Page 55

Appendix

- 55 -

English

Step 2: The process of system reading the BIOS file from the floppy disk is displayed on the screen.

When the message "Are you sure to update BIOS?" appears, press ENTER. The BIOS update
will begin and the current process will be displayed.

1. Do not turn off or restart the system when the system is reading/updating the BIOS.
2. Do not remove the floppy disk or hard drive/USB drive when the system is updating the BIOS.

Step 3: When the update process is complete, press any key to return to the Q-Flash main menu.

Step 4: Press ESC and then DELETE to exit Q-Flash and the system will restart. As the system reboots,

you will see the new BIOS version during POST.

Step 5: As the system reboots, press DELETE to enter BIOS Setup. Select Load Optimized Defaults

and press ENTER to load BIOS defaults. System will re-detect all peripherals devices after
BIOS update, so we recommend that you reload BIOS defaults.

Press Y to load BIOS defaults

Step 6: Select Save & Exit Setup and then press Y to save settings to CMOS and exit BIOS Setup.

When the system restarts, the whole update process is complete.

Q-Flash Utility v2.02

Flash Type/Size.................................SST 49LF004A/B

512K

Keep DMI Data

Enable

Update BIOS from Drive

Save BIOS to Drive

Enter : Run

:Move ESC:Reset F10:Power Off

!! Copy BIOS completed - Pass !!

Please press any key to continue

c. Select the BIOS file and press ENTER.

Make sure again the BIOS file matches your motherboard model.

Standard CMOS Features
Advanced BIOS Features
Integrated Peripherals
Power Management Setup
PnP/PCI Configurations
PC Health Status
Frequency/Voltage Control

ESC: Quit

: Select Item

F8: Q-Flash

F10: Save & Exit Setup

Load Optimized Defaults

Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving

Load Optimized Defaults (Y/N)? N