Grizzly G0592 - Manual (Page 20)

-18-
G0592 Metal Cutting Bandsaw
Chip Trays & Splash
Guard
Components and Hardware Needed: Qty
Upper Chip Tray ................................................ 1
Lower Chip Tray ................................................ 1
Splash Guard .................................................... 1
The upper chip tray needs no hardware and rests
on the vise and vise base as shown in
Figure
11.
The lower chip tray rests on the base directly
under the upper chip tray. It is not secured so it
can be removed for easy clean-up.
Figure 12. Splash tray installation.
Figure 13. Feed stop.
Jam Nut
Feed Stop
Feed Stop
Figure 11. Chip tray set-up.
Upper Chip Tray
Lower Chip Tray
The splash tray fits over the lip of the base as
illustrated in
Figure 12.
Depending on how the G0592 was shipped, it
may be necessary to adjust the feed stop before
the test run. The blade should not make contact
with any part of the vise assembly.
To adjust the feed stop bolt:
1. Adjust the feed stop bolt and jam nut (Figure
13), so the bandsaw blade teeth are just
below the vise table surface when the cut is
complete.