Grizzly G4008 - Manual (Page 13)

G4008/G4009 Drill Press -11-
Figure 10.
1. Remove the motor mount bolts from the
motor mount.
2. You will need help for this step: Attach the
motor to the motor mount using the hardware
removed in
Step 1. Lightly tighten down the
bolts.
3. Slide the motor pulley onto the motor shaft
lining up the setscrew with the flat spot on
the motor shaft. Tighten the setscrew.
4. Install the V-Belt and adjust the motor as
necessary so the pulleys line up correctly.
Figure 10.
Motor
Figure 11.
1. Remove the wire box cover located at the
end of the motor.
2. Wire the motor per the diagram in Figure 11.
NOTE: The wires from the switch, besides the
ground wire, are interchangeable; therefore their
colors are not specified.
3. Attach the ground wire securely to the green
screw located on the back of the motor.
4. Attach motor wire cover.
5. If the motor runs backwards, reverse the
positions of motor wires #5 and #8.
Motor Wiring