GE VERTICAL DRILLING MOTOR GE752 - Manual (Page 58)

GEK–91584D, Vertical Drilling Motor, Type GE752
58
FIG. 34. DRIVE–END BEARING ASSEMBLY. E–18166E.
SMEAR 0.50 OZ. OF
GREASE
ON GREASE SEALS.
MODELS
SEE TABLE 2, PAGE 20
NOTE: Do not heat the bearing and housing as-
sembly above 100
_
C (212
_
F). Higher tempera-
tures may cause the oil to “bleed” from the
grease.
7. Heat spacer (9) to 110
_
C (230
_
F) and shrink it
onto the shaft tight against the inner race of ball
bearing (3).