Genicom 3850 - Manual (Page 61)

57
On Line after Paper Load Sequence
The printer will enter the online (Y) or offline (N) condition following a paper load sequence
based upon your selection.
OPT: ONLIN AT LOD ENTER
OPT:ONLIN LOAD>N ↓
OPT:ONLIN LOAD:Y ↓
Ribbon Type Selection
Informs the firmware which type of ribbon is installed (not affected by ISU).
If PROCESS (process ribbon) or RED/BLK (red/black ribbon) are selected, then the printer
will respond to receive color select commands.
If BLACK (black ribbon) is selected, then an automatic ribbon shift will occur if the color kit
option is installed.
OPT: RIBBON TYPE ENTER
OPT:RBN>BLACK ↓
OPT:RBN:PROCESS ↓
OPT:RBN:RED/BLK ↓
Printhead Gap to Path or Format Assignment
Based upon your selection the printer will save a print head gap value either to the
current paper path or to the format during the print head gap setting routine in the
Operational Menu. (see A
A A d d d j j j u u u s s s t t t i i i n n n g g g f f f o o o r r r t t t h h h e e e T T T h h h i i i c c c k k k n n n e e e s s s s s s o o o f f f Y Y Y o o o u u u r r r F F F o o o r r r m m m s s s section).
If you select PATH, then the printer will establish a new gap whenever you load a new
paper path.
If you select FORM, then the printer will establish a new gap whenever you select a new
format or whenever you load a paper path to which a format has been assigned.
OPT: GAP ASSIGN ENTER
OPT:GAP TO>PATH ↓
OPT:GAP TO:FORM ↓