GarrettCom Magnum ST80 User Manual
Page 26
Stackable Personal Hubs
Installation and User Guide (04/01)
21
www GarrettCom com
.
.
4.4
Using the Stack Enable switch
The Stack Enable switch of the ST80 is used to configure each unit of the
stack. If an ST80 is being used as a non-stacked unit, the Stack Enable switch must be in
the “OFF” position. When two or more ST80s are stacked, the bottom unit should be set
to the “OFF” position, and all other units should be in the “ON” position. For further
information about the Stack Enable switch, see Section 3.9, “Stacking the ST80s”.
See also other documents in the category GarrettCom Computer Accessories:
- Industrial Network Track OSI (10 pages)
- 6K16V (61 pages)
- CSN14 (71 pages)
- DS80F (27 pages)
- MAGNUM CSG14U (82 pages)
- Magnum MNS-6K (329 pages)
- MNS-6K-SECURE 14.1.4 (364 pages)
- 1024 (44 pages)
- 6K32 (65 pages)
- MAGNUM DS80C (27 pages)
- P80F (28 pages)
- PS14P (76 pages)
- 6K32T (78 pages)
- DS8016 (42 pages)
- P62 (40 pages)
- CSG14U (82 pages)
- 4K-Series (45 pages)
- 6K8 (76 pages)
- Quad (56 pages)
- DS60s (39 pages)
- P62-Series (37 pages)
- Magnum S14 (61 pages)
- MAGNUM H80P (31 pages)
- Hubs (12 pages)
- Ethernet Networks and Web Management (12 pages)
- 4K16 (38 pages)
- 14E (66 pages)
- MAGNUM 6KM (46 pages)
- DS 880 (32 pages)
- 6K25 (67 pages)
- Magnum 3000 (59 pages)
- MAGNUM 6KQE (50 pages)
- Magnum 6KQ (2 pages)
- ES42 (77 pages)
- 8000X (63 pages)
- 500-Series (34 pages)
- S14 (77 pages)