Stovax 5 - Manual (Page 16)

16
2.4 Remove the two screws at the back of the firebox and lift
the burner unit clear. See diagram 3.
3.1 Follow the procedure for removing the main burner, when
the burner is removed from the stove, remove the front
aeration guide by undoing the two screws. See diagram 4.
3.2 Remove the lint arrestor, by folding the tabs back. See
diagram 5.
1.1 All principal components can be replaced without removing
the stove from its installation, although it is essential that the
gas supply to the appliance is turned off at the isolation
device before proceeding further.
For information on the handling and disposal of fire
ceramics please refere to section 5, Cleaning the Fire, in the
user instructions.
ENSURE THAT THE APPLIANCE IS COLD BEFORE
STARTING WORK ON IT!
2.1 Turn the gas supply off at the isolation device, remove the
door lock screw by using the 2mm Allen key and open the
door. Carefully remove the ceramic fuel bed components.
2.2 Remove the cover plate from the bottom of the stove by
undoing the 6mm bolt, and place to one side. See diagram
1.
2.3 Disconnect the thermocouple from the gas valve (A),
remove the ignition lead from the electrode (B). cut the
cable tie if required, undo the compression nut (C) from the
pilot unit and undo the compression nut on the injector (D).
See diagram 2.
1. GENERAL
SERVICING INSTRUCTIONS
REPLACING PARTS
2. MAIN BURNER
3. PILOT UNIT
AR1441
AR1449
AR1444
AR1443
AR1442
D
A
B
1
2 C
3
4
5