Grundig GLCD1906HDV User Manual
Page 15
14
2. Channel ‘1’ will appear on the left top corner of the screen after the
channel scanning is finished. Press the CH- or CH+ button to select the
previous or next channels or press the 0-9 buttons to enter a channel
number directly.
3. Press
the
button on the remote control to switch between the
present channel to the last channel was viewed.
4. Press
the
P.MODE button repeatedly to cycle through the available
video picture modes from the below different types
5. Press
the
S.MODE button repeatedly to cycle through the available
sound modes from the below different types
6. Press
the
MUTE button to cut off the sound output, press this button
again to resume sound output.
7. Press
the
DISPLAY button to display the preset channel information.
(3) View different input signal sources
Press the SOURCE button then press the
or button to select the
available input sources as follow:
(4) View the TELETEXT program
1. Press
the
SOURCE button to select the DTV mode. Then press the CH-
or CH+ button on the remote control to select a DTV channel in order to
pick up the TELETEXT signal, if broadcast.
Standard
Mild
User
Dynamic
ATV
AV
S-Video
YPBPR
DVD
VGA
DTV
HDMI
Music
Movie
Sports
User
Standard