Grizzly G0512 - Manual (Page 19)

G0512 Edge Sander -17-
Figure 14. Front L support installed.
Figure 16. Allen wrench placed between platen
and table.
Figure 17. Three places to ensure the spacing
between the sanding belt and the table is even.
4. Install the front L support with the lock han-
dle and two
3 ⁄
8
" flat washers as shown in
Figure 14.
5. Install the L supports with the lock handles
and remaining four
3 ⁄
8
" flat washers as shown
in Figure 15. The smallest L support at the
rear of the machine should be closest to the
motor.
6. Lower the lead screw support all the way
down and adjust all of the L support brackets
up to approximately the same height. This
will prepare the brackets for the table place-
ment.
7. Place the table on the supports.
8. Use a 3mm or 1 ⁄
8
" Allen wrench as a gauge to
position the table evenly away from the plat-
en and the idler roller. Do this by placing the
Allen wrench as shown in
Figure 16, at the
three locations shown in Figure 17.
9. Clamp the table to the supports or have an
assistant hold the table in place, and secure
the table to the supports with the #8 x
3 ⁄
4
"
Phillips head tap screws provided in the
hardware bag.
Figure 15. Rear L supports installed.