Grizzly G0512 - Manual (Page 16)

-14- G0512 Edge Sander
Figure 9. Dust port attached to brackets.
To attach the dust port:
1. Attach the dust port to the support brackets
with the three
5 ⁄
16
"-18 x 1 ⁄
2
" hex bolts and
washers, as shown in Figure 9, but DO NOT
completely tighten the bolts yet.
2. Position the dust port approximately 1 ⁄
2
" away
from the driver roller and tighten the two
attachment bolts from
step 1.
The voltage you decide to use with your sander
will determine which plug and receptacle you
install. Read
pages 6 & 7, in Section 3: Circuit
Requirements for more information.
Install the plug and receptacle now.
Connecting Plug to
Cord
Attaching Dust Port