Grizzly G0458 - Manual (Page 24)

-22-
Model G0458 (Mfg. Since 5/11)
paper replacement
tools needed: Qty
Flat head Screwdriver ...................................... 1
hex Wrench 4mm .............................................. 1
hex Wrench 5mm .............................................. 1
Carton Cutter or Utility Knife ............................. 1
the model g0458 is designed for 3" wide sandpa-
per rolls. turn to
section 5: accessories on
page 24 for grit selection and model numbers.
to change the paper:
1. disconnect power to the sander!
2. open the top cover, remove the three cap
screws that secure the chip deflector to the
sander frame, and set the deflector aside.
3. loosen the cap screw on the right spring-
loaded clamp as shown in figure 20.
6. loosen the cap screw on the left clamp and
remove the sandpaper.
7. Use the old sandpaper as a pattern, or use
the pattern in figure 21, to cut a new piece of
sandpaper to the necessary shape. After cut-
ting the 12
1 ⁄
2
" angled sides, measure 2" along
the same sides and cut off the ends with a
knife.
figure 21. Sandpaper pattern.
87"
12
1
⁄
2
"
2"
2"
3"
12
1
⁄
2
"
4. remove the sandpaper from the clamp.
note: You can use a flat head screwdriver to
loosen the clamp to free the sandpaper.
5. rotate the drum to remove the sandpaper
belt.
figure 22. Securing sandpaper in left clamp.
8. insert the left corner of the new sandpaper
into the left clamp and tighten the cap screw
as shown in
figure 22. the angled side of
the sandpaper must be flush with the left
drum edge. if the sandpaper overlaps the
edge, you may have difficulty closing the
cover.
figure 20. loosening cap screw on right spring-
loaded clamp.
Access
hole
right
Clamp
tension
Wheel
left
Clamp