Grizzly G1007 - Manual (Page 27)

BdYZa<&%%+$<&%%,B[\#H^cXZ.$%.
"'*"
Power Connection
6[iZg ndj ]VkZ XdbeaZiZY Vaa egZk^djh hZije
^chigjXi^dchVcYX^gXj^igZfj^gZbZcih!i]ZbVX]^cZ
^hgZVYnidWZXdccZXiZYidi]ZedlZghjeean#
Id Vkd^Y jcZmeZXiZY hiVgijeh dg egdeZgin YVb"
V\Z!jhZi]Z[daadl^c\hiZehl]ZcZkZgXdccZXi^c\
dgY^hXdccZXi^c\i]ZbVX]^cZ#
Connecting Power
Figure 26. Connecting power.
1. Ijgci]ZbVX]^cZedlZghl^iX]OFF#
2. >chZgi i]Z edlZg XdgY eaj\ ^cid V bViX]^c\
edlZg hjeean gZXZeiVXaZ# I]Z bVX]^cZ ^h
cdlXdccZXiZYidi]ZedlZghdjgXZ#
Disconnecting Power
Figure 27. Disconnecting power.
1. Ijgci]ZbVX]^cZedlZghl^iX]OFF#
2.
djid[i]ZgZXZeiVXaZ#9dcdiejaaWni]ZXdgY
Vhi]^hbVnYVbV\Zi]Zl^gZh^ch^YZ#
All types of milling cutters and drill bits are
sharp. It is recommended that these not be
handled directly. Use paper towels to hold
sharp tooling to avoid cuts to your hands.
Be careful while handling them and store
them in a child safe location.
Fly Cutter/Arbor
Your Mill/Drill comes equipped with a fly cutter
that fits on the 1" stub end of the R-8 arbor.
To install the fly cutter:
1. Clean all grease, oil and debris off the R-8
arbor.
2. Clean all grease, oil and debris off the fly cut-
ter.
3. Fit the fly cutter onto the stub end of the arbor
so the keys on the arbor and the keyways on
the fly cutter come together (Figure 25).
Figure 25. Fly cutter.
4. Secure the fly cutter to the arbor with the cap
screw and washer provided.
5. Install the arbor with fly cutter into the Mill/
Drill as described in Collet/Arbor on Page
23.
Cap Screw
Flat Washer
Fly Cutter
R-8 Arbor