GE Monogram ZET737BW - Manual (Page 15)

15
Installation
Built-In Ovens
• When connecting to a 4-conductor branch circuit:
– Connect oven red lead to branch circuit red lead.
– Connect oven black lead to branch circuit black
lead.
– Break connection between oven white lead and
oven bare copper conductor.
– Connect oven white lead to branch circuit neutral
lead (white or gray).
– Connect oven bare copper conductor to branch
circuit ground lead (green or bare copper).
Note: Aluminum house wiring
requires use of special
aluminum-to-copper connectors.
Follow manufacturer’s
instructions carefully.
• When connecting to a 3-conductor branch circuit:
– Connect oven red lead to branch circuit red lead.
– Connect oven black lead to branch circuit black
lead.
– Connect oven bare copper conductor and white
lead to branch circuit neutral lead (white or gray).
Secure
oven
to cabinet • Position the flexible conduit on top of the oven in
such a manner that it will not interfere with proper
installation.
• Slide oven into cabinet opening.
• Drill 3/32" pilot holes through mounting holes in
oven front frame. (4 holes for single oven, 8 holes
for double oven.)
• The screws must be within 1/4" of the front edge of
the cutout.
• Secure oven in place with screws furnished. (Use
drywall or particle board screws if cabinet is particle
board).
CAUTION Be sure you do not tip the unit forward during
installation or you may bend the Lower Side Trim.
CAUTION WARNING
Securely fasten oven to cabinet using the
screws provided.
Failure to do so could
cause the oven to move or tip during use
and result in personal injury.