Grindmaster AM-344-04 - Manual (Page 11)

Shuttle Brewers & Airpot/Shuttle Brewers Page 11
Programming (cont.)
Settings Routine
Programming For Medium : Brew Time, Pulse Brewing & Bypass (refer to Table 2)
1 1. Press and hold both “up” and “down” arrows for 5 seconds.
1 2. All three brew lights will flash.
1 3. Press “Medium Brew” button.
Only “Medium” ready light illuminates during remaining steps.
1 4. Display will read “Br” (Brew Time).
1 5. Press “Medium Brew” button to go to next setting.
1 6. Display will read set brew time in minutes and seconds (0.01-6.00). Default is “2.40”.
1 7. Press “up” or “down” arrow to change value. (1 second increments)
1 8. Press “Medium Brew” button to accept and go to next setting.
1 9. Display will read “P-b” (Pulse Brewing).
10. Press “Medium Brew” button to accept and go to next setting.
11. Display will read “Off” or “1” – “6” (number of pulses). Default is 2.
12. Press “up” or “down” arrow to change value (1 second increments). (Approximately 0.8 oz./second.)
13. Press “Medium Brew” button to accept and go to next setting.
Note: If “Off” is selected, skip pulse timing steps.
14. Display will read “0.05” – “0.60” (pulse ON time for each pulse). Default is “0.30”.
15. Press “up” or “down” arrow to change value. (increments of 1 second)
16. Press “Medium Brew” button to accept and go to next setting.
17. Display will read “0.05” – “0.60” (pulse OFF time for each pulse). Default is “0.30”.
18. Press “up” or “down” arrow to change value. (increments of 1 second)
19. Press “Medium Brew” button to accept and go to next setting.
20. Display will read “b-P” (percent of brew volume to be bypassed).
21. Press “Medium Brew” button to go to next setting.
22. Display will read “Off” or “1” – “33” (bypass %). Default is “OFF”.
23. Press “up” or “down” arrow to change value. (increments of 1 percent)
24. Press “Medium Brew” button to accept and clear display.
Table 2
(OFF, 1 - 6)
TO
BYPASS
ADVANCE
PULSE BREW
ADJUST
BREW TIME
READING
# OF PULSES
BYPASS % (OFF, 1-33)
DISPLAY
(MAX MAY CHANGE DEPENDING ON RATIO)
1. PRESS-AND-HOLD UP & DOWN ARROWS FOR 5 SECONDS.
2. READY LIGHTS WILL FLASH.
3. PRESS BREW BUTTON FOR MEDIUM "M".
4. MEDIUM READY LIGHT FLASHES THROUGHOUT ROUTINE.
5. DISPLAY WILL READ AS FOLLOWS:
BREW TIME (0:01-6:00)
2 minutes, 40 seconds shown
PULSE OFF TIME (0:05-0:60)
# of seconds shown
PULSE ON TIME (0:05-0:60)
# of seconds shown