Global Machinery Company REDEYE LS250TS2000W User Manual

Page 12

2. Using a 13mm spanner

(not supplied) loosen the

hex bolt on the riving knife

clamp (fig R) and insert

the riving knife between

the metal plate and the

clamp block (fig S).

3. Loosen the blade lock (24)

by lifting it up (fig T)

and turn the blade height

adjustment handle (20)

to raise the blade to its

highest position (fig U).

4. Tighten the blade lock (24)

by pushing it back down

towards the table saw.

5. Adjust the height of the

riving knife so that the

gap between the knife

and the teeth of the blade

is even along the curve of

the blade and is not more

than 5mm.

6. Tighten the hex bolt to

secure the riving knife

in place.

7. Replace the table insert (13).

Fitting the blade guard

1. Remove the nut, screw

and 2 washers from the

blade guard.

2. Fit the blade guard onto

the top of the riving knife

ensuring that the slot in

the blade guard lines up

with the slot in the

riving knife.

3. Fit one flat washer onto the screw and place the

screw through the blade guard, riving knife and

blade guard again.

4. Fit the second flat washer

onto the end of the screw

followed by the nut.

5. Tighten the nut to

secure the blade guard in

position (Fig V) but do

not overtighten as this will

prevent the blade guard

from moving up and down

freely as the workpiece

passes below it.

Using the mitre gauge holder

1. The table saw features a mitre gauge holder on the

right hand side of the housing.

2. Slide the mitre gauge into the holder until it clicks into

place and is secure in the holder (fig W).

3. To remove the miter gauge

depress and hold both

latches on the holder and

pull out the mitre gauge.

Using the push stick holder

1. The table saw features

a push stick holder on

the right hand side of

the housing.

2. To insert the push stick place the tip of the push stick

into the bracket on the right hand side.

3. Lower the handle and rest it on the bracket on the left

hand side (Fig W).