Grandstream Networks 200 User Manual
Page 26
![background image](/manuals/106651/26/background.png)
Grandstream Networks, Inc.
BT200 User Manual
Page 26 of 33
Firmware 1.1.6.44
Last Updated: 12/2008
Call Progress
Tones
Using these settings, users can configure ring or tone frequencies based on parameters
from local telecom. By default, they are set to North American standard.
Frequencies should be configured with known values to avoid uncomfortable high pitch
sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order
to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern. Up to three cadences are supported.
Disable Call
Waiting
Default is No. If set to Yes, the call waiting will be disabled.
Disable Direct
IP calls
Default is No. If set to Yes, direct IP calls will be disabled.
Use Quick IP
Call Mode
Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP
address.
In the Advanced Settings page there is an option “Use Quick IP-call mode”. Default
setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and XXX <=255,
phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the
local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode
for details.
Disable
Conference
Default is No. If set to Yes, conference calls will be disabled
Lock keypad
update
If set to “Yes”, the configuration changes via keypad are disabled.
Disable DND
Default is No. If set to ‘Yes’, DND key on keypad will be disabled
Send Flash
Event
Default is No. If set to yes, flash will be sent as DTMF event.
Headset TX
gain(dB)
Transmission gain. Its a headset setting to control the voice intensity
Headset RX
gain (dB)
Receive gain. It’s a headset setting to control the voice intensity.
Table 12: SIP Account Settings
Account Name
The name associated with each account - displayed on LCD.
SIP Server
SIP Server’s IP address or Domain name provided by VoIP service provider.