Notice, Cleaning – Grizzly H6331 User Manual

Page 14

Model h6331 hVhp spray gun set

-14

section 6: maintenance

cleaning

proper cleaning is the best way to ensure
trouble free performance from your spray
gun. if your gun is not thoroughly cleaned,
damage and poor spraying will result.
problems caused by improper cleaning will
not be covered by the warranty. Clean the
spray gun immediately after each use.

to clean your spray gun:

1. spray a small amount of solvent

through the spray gun.

note: Check with local laws regarding
this practice. Spraying solvents into
the air may be illegal in your area. A
cabinet style spray gun cleaner may be
required.

2. disconnect the gun from the com-

pressed air!

notice

do not soak the spray gun body
in solvent. prolonged exposure to
solvent will rapidly deteriorate the
spray gun washers and seals. ignoring
this notice will void your warranty.

eXplosion hazard! chlorinated
solvents like tricloroethane and
methylene chloride (methyl chloride)
can chemically react with aluminum
and may explode. many parts in
spray guns are made of aluminum.
read solvent label carefully before
using solvent.

3. remove the reservoir and lid.

4. disassemble the gun by unscrewing

the fluid control knob, then remove the
spring and needle (

figures 13 and

14).

5. unscrew the atomizing cap with your

fingers and the fluid tip with a wrench.
the fully disassembled gun should
look like

figure 13 and 14.

figure 14. large gun disassembled.

atomizing Cap

Fluid tip

spring

Fluid Control Knob

needle

lid

figure 13. small gun disassembled.