GIGABYTE GN-BTD01 - Manual (Page 25)

GN-BTD01 Bluetooth User’s Guide
7 Troubleshooting
Q1: Can’t connect to a paired device?
- Check the remote paired device is within radio range and powered up
and then attempt the connection again.
Q2: Can’t discover services on an un-paired remote device?
- Verify that remote device is powered up and in Connectable mode
(Bluetooth Configuration panel \ Accessibility tab). Click the
“Search For Devices” to verify that the device is within range.
Q3. Dial-up Networking service does not start?
- Please check the modem is usable as a local device from the server.
Open the “Bluetooth Configuration panel \ Local Services” tab then
double-click the “Dial-up Networking” service. Select the one
modem that will be used to dial out. Click the OK button to close the
dialog box. Click OK button in the Bluetooth Configuration panel to
activate the setting.
Q4. How do I decide the Bluetooth Device Address (BDA) of my
device?
- Open the “Bluetooth Configuration panel \ Hardware” tab. The
Bluetooth Device Address will be displayed in the Device Properties
section of the dialog box.
Q5. How do I decide the version number of the Bluetooth Specification
that the Host Controller Interface (HCI) complies with?
- Open the “Bluetooth Configuration panel \ Hardware” tab. The
Bluetooth Specification compliance and the Specification Revision
information for the Host Controller Interface will be displayed in the
Device Properties section of the dialog box.
Q6. How do I decide the version number of the link Manager Protocol
(LMP)?
- Open the “Bluetooth Configuration panel \ Hardware” tab. The Link
Manager Protocol version number and the sub-version number
information will be displayed in the Device Properties section of the
22