Flymo SCIROCCO 2500 - Manual (Page 6)

How to Use
WARNING
The use of eye protection is recommended. The use of
ear protection is recommended. To prevent dust irrita-
tion, the wearing of a face-mask is recommended.
Never point your product at bystanders.
• The product has 2 modes of operation.
• These can be selected by moving the mode indicator (N) to
adjust the nozzle position for blow or vacuum mode.
Using As A Blower
Blow Mode - The product will blow debris from patios,
paths, driveways, lawns, bushes, borders etc.
1. Select the blow position on the mode indicator (N1)
2. Point nozzle towards the ground.
3. To start squeeze the switch lever (P).
4. Stand back from debris to be cleared.
5. Point the tube towards the debris and slowly approach.
6. To stop release the switch lever.
• If Blow performance is reduced, the tube may be
blocked. Open the Blockage Clearing Cap (Q1)
and clear the Blockage with blunt edge imple-
ment (Q2)
Using As A Vacuum
Vacuum Mode - In this position your product will pick
up leaves, small twigs and garden debris.
1. Select the vacuum position on the mode indicator.
(N2).
2. Position the tube slightly above the debris, squeeze
the switch lever (P) and move the product slowly
back and forth.
3. Do not force the tube into the debris as this will
impair performance.
4. To stop release the switch lever.
N
1
2
P
R1 ✔
✕ ✕
Emptying Your Product
1. Remove the Debris Bag as described in the
Assembly section.
2. Empty debris bag holding the moulded handle
at the top of the bag and the fabric handle at
the bottom of the bag. (R1)
D O N OT P LACE H ANDS IN B AG W HEN E MPTYING ,
S
HARP
D
EBRIS
C
AN
C
AUSE
I
NJURY
(R2)
3. Re-fit the Debris Bag as described in the
Assembly section.
Emptying your Product
R2
Q1 Q2